Motherboard 4 PIN System Fan port splitter

[Shawon191]

Need a Y-splitter/hub to use 2 case fans on the same 4 pin System fan slot. Any idea where I can get this? Looked in a couple of shops in IDB who sell this kind of stuff, but they didn't have it.

- - - Updated - - -

bump!

[Swapnil]

You'll need to bring them from abroad. Either through Backpack or from Aliexpress.

[redwan hasan]

Need a Y-splitter/hub to use 2 case fans on the same 4 pin System fan slot. Any idea where I can get this? Looked in a couple of shops in IDB who sell this kind of stuff, but they didn't have it.

- - - Updated - - -

bump!

What are you actually looking for?
3+4 pin to 4 pin?

[Shawon191]

What are you actually looking for?
3+4 pin to 4 pin?

3+3 will suffice for now, don't have a controller.

[redwan hasan]

3+3 will suffice for now, don't have a controller.

Unfortunately they are pretty hard to find, yet you can try finding it in multiplan center elephant road, shops near the escalator or what I would have done is buy(I usually have them laying around) some jumper wire, female on one end and male or female on other end and just splice and solder them.
kinda like this.
https://1.bp.blogspot.com/-msDqtq_VI...524_064633.jpg

[Shawon191]

Unfortunately they are pretty hard to find, yet you can try finding it in multiplan center elephant road, shops near the escalator or what I would have done is buy(I usually have them laying around) some jumper wire, female on one end and male or female on other end and just splice and solder them.
kinda like this.
https://1.bp.blogspot.com/-msDqtq_VI...524_064633.jpg

Can I make my own from these? Or will the wires melt?

[redwan hasan]

Can I make my own from these? Or will the wires melt?

lol
most 12V medium sized case fan takes only about 200mA, so they will be fine.
I will ask you to make one for urself, much easier. Careful about polarity and do not short.